Manual for OpenTX 2.2
  • Introduction
  • The radio
  • Build Options
  • Companion
    • Basic Concepts
    • Setting up OpenTX Companion
    • Flashing Frsky Radios
  • Software overview
    • Navigation
    • Model Selection
    • Main views
    • Telemetry views
    • Radio menus
      • SD Browser
      • Global Functions
      • Trainer
      • Version
      • Diagnostics
      • Hardware
      • Calibration
    • Model menus
      • Model Setup
      • Heli Setup
      • Flight Modes
      • Inputs
      • Mixer
      • Outputs
      • Curves
      • Global Variables
      • Logical Switches
      • Special Functions
      • Custom Scripts
      • Telemetry
  • First steps
  • Advanced features
    • Flight modes
    • Telemetry Values
    • Audio
    • Global variables
    • Flashing the bootloader
    • Add-ons
    • S-PORT flashing
    • Build Option
    • Joystick emulation
    • Managing Throws
  • SD Card contents
  • Model Setup Examples
    • Standard Four Channel
    • Basic Elevon
    • Flaps - One Servo
  • FAQ
  • Contributors
Powered by GitBook
On this page

Was this helpful?

  1. Software overview

Telemetry views

A LONG press of the PAGE key from any of the main views brings up the telemetry views. The PAGE and +/- keys will then cycle between the power status screen (voltage, current, power or A1/A2 if not set, cell voltages from an FLVS-01 sensor if connected), the min/max and GPS coordinates screen, and if defined from one to three customs screens that can hold up to 12 items each, configured in the telemetry setup menu.

PreviousMain viewsNextRadio menus

Last updated 4 years ago

Was this helpful?