Manual for OpenTX 2.2
  • Introduction
  • The radio
  • Build Options
  • Companion
    • Basic Concepts
    • Setting up OpenTX Companion
    • Flashing Frsky Radios
  • Software overview
    • Navigation
    • Model Selection
    • Main views
    • Telemetry views
    • Radio menus
      • SD Browser
      • Global Functions
      • Trainer
      • Version
      • Diagnostics
      • Hardware
      • Calibration
    • Model menus
      • Model Setup
      • Heli Setup
      • Flight Modes
      • Inputs
      • Mixer
      • Outputs
      • Curves
      • Global Variables
      • Logical Switches
      • Special Functions
      • Custom Scripts
      • Telemetry
  • First steps
  • Advanced features
    • Flight modes
    • Telemetry Values
    • Audio
    • Global variables
    • Flashing the bootloader
    • Add-ons
    • S-PORT flashing
    • Build Option
    • Joystick emulation
    • Managing Throws
  • SD Card contents
  • Model Setup Examples
    • Standard Four Channel
    • Basic Elevon
    • Flaps - One Servo
  • FAQ
  • Contributors
Powered by GitBook
On this page

Was this helpful?

  1. Software overview
  2. Model menus

Flight Modes

Next up is the flight modes screen.

8 flight modes plus the default one are available for use. Each of them can be named, has a selectable activation switch (physical or logical), a trim selection array (R, E, T, A when shown mean the mode has its own trim setting for that control, but each can be changed to a number from 0 to 9 and thus use the same value as the specified mode), and slow up/down parameters for smooth transitions between modes. The priority of the flight modes is such as the first FM of 1-8 that has its switch ON is the active one. When none has its switch ON, the default FM0 is active.

PreviousHeli SetupNextInputs

Last updated 4 years ago

Was this helpful?