Manual for OpenTX 2.2
  • Introduction
  • The radio
  • Build Options
  • Companion
    • Basic Concepts
    • Setting up OpenTX Companion
    • Flashing Frsky Radios
  • Software overview
    • Navigation
    • Model Selection
    • Main views
    • Telemetry views
    • Radio menus
      • SD Browser
      • Global Functions
      • Trainer
      • Version
      • Diagnostics
      • Hardware
      • Calibration
    • Model menus
      • Model Setup
      • Heli Setup
      • Flight Modes
      • Inputs
      • Mixer
      • Outputs
      • Curves
      • Global Variables
      • Logical Switches
      • Special Functions
      • Custom Scripts
      • Telemetry
  • First steps
  • Advanced features
    • Flight modes
    • Telemetry Values
    • Audio
    • Global variables
    • Flashing the bootloader
    • Add-ons
    • S-PORT flashing
    • Build Option
    • Joystick emulation
    • Managing Throws
  • SD Card contents
  • Model Setup Examples
    • Standard Four Channel
    • Basic Elevon
    • Flaps - One Servo
  • FAQ
  • Contributors
Powered by GitBook
On this page

Was this helpful?

  1. Model Setup Examples

Standard Four Channel

PreviousModel Setup ExamplesNextBasic Elevon

Last updated 4 years ago

Was this helpful?

In a standard four channel setup, the simplest way to set up your model is to use the model wizard.

If you cancel the model wizard, the default setup is to provide four channels configured appropriate to your radio settings.

You will notice on the mixer screen that there is an capital letter I next to each of the names. This refers to the corresponding item on the input screen.

To find out more about what can go on these screens, review and sections.

Inputs
Mixer